RFX Mapping Button OEM Suzuki

The buttons and switches of the RFX Race series are OEM replacement parts. They come with the same fittings, fasteners, connectors, and cable lengths as the original part.

Available for a wide range of motorcycles.

• OEM replacement
• Compatible with all original connectors
• OEM cable length

Mounting instructions:

• Start by removing the front panel.
• Carefully cut the cable ties holding the starter and stop switch cables to the bars, then unscrew the clamps and let them hang.
• Locate the switch connector on the motorcycle, they are often near the steering column on the chassis, but sometimes under the tank.
• Detach the connector and remove the switch, noting the routing of the wires.
• Clean the connector using an electrical contact cleaner.
• Slightly attach the new switch to the handlebars at the desired location.
• Route the wires as done with the old switch and reconnect the connector.
• Check the freedom of movement of the wires by turning the handlebars fully and ensuring the wires are not too tight, adjust if necessary.
• Reposition the cable ties on the wires, placing the cables at the back of the bars to avoid damage from debris.
• Reinstall your front panel.

Specifications:

• weight (g): 61
• width (mm): 108
• height (mm): 43
• length (mm): 166
• volume (cm³): 771