RFX Motorcycle circuit breaker Honda CRF 450 R (Pe07)

The buttons and switches from the RFX Race series are OEM-type replacement parts. They come with the same connectors, fastenings, and cable lengths as the original part.

Available for a wide range of motorcycles.

• OEM replacement
• Works with all original connectors
• OEM cable length

Installation instructions:

• Start by removing the front plate.
• Carefully cut the zip ties holding the starter and kill switch cables to the bars, then unscrew the clamps and let them hang.
• Locate the switch connector on the motorcycle; they are often near the steering column on the frame but sometimes under the tank.
• Detach the connector and remove the switch, taking note of how the wires are routed.
• Clean the connector using an electrical contact cleaner.
• Lightly mount the new switch on the handlebars in the desired position.
• Route the wires as they were on the old switch and reconnect the connector.
• Check the freedom of movement of the wires by turning the handlebars fully and ensuring the wires are not too tight, adjusting if necessary.
• Reposition the zip ties on the wires, placing the cables at the back of the bars to avoid damage from projections.
• Replace your front plate.

Specifications:

• weight (g): 60
• width (mm): 100
• height (mm): 30
• length (mm): 200
• volume (cm³): 600